Gateway 8510 ATI Display Driver
This card's graphics processor and memory mean that it is currently among the leaders in its class, and it should run all modern games at high resolution and Missing: Gateway Results 1 - 48 of 64 - Gateway PA6 ME NVIDIA VIDEO CARD W-HEATSINK .. HP p w ATI RADEON HD MB Video MXM. It comes with an ATI x 64MB GPU. I have a Gateway GZ. In the Advanced Display Properties, Adapter tab, how much memory is.
Type: | Driver |
Rating: | 4.48 154 (4.48) |
Downloads: | 772 |
File Size: | 8.15Mb |
Supported systems: | Windows 7/8/10, Windows XP 64-bit, Mac OS X 10.X |
Price: | Free* [*Free Registration Required] |
Gateway 8510 ATI Display Driver
On the picture below you can see both connectors unlocked and cables removed.
- [ Gateway ] Big Savings. Refurbished and New @ to
- Gateway 8510GZ Review (pics, specs)
- How to disassemble HP Compaq 8510p
- User Guide
- The #1 Shopping App !
The locking tab must stay attached to the connector base. STEP 9 Remove two screws securing the cooling fan. Unplug the fan cable from the motherboard.

Remove the heat sink. STEP 11 Remove two screws securing the video card. The video card will pop up at a degree angle. Carefully pull the video card from the slot by the edges. Remove all screws from the bottom case.
The orange screw securing the touch pad. There are two more screws marked with green squares hidden under rubber seals. As you see, you can access the Bluetooth card through the hard drive compartment. STEP 13 Lift up the touch pad Gateway 8510 ATI Display as it shown on the picture below.
Ubuy Products - Gateway M
Place the touch pad upside down on the palm rest. Disconnect the touch pad cable from the motherboard. Remove the touch pad. STEP 14 Start removing the keyboard bezel with a small screwdriver.
Gateway 8510 ATI Display Do not forget to disconnect the cable the same way as you disconnected the keyboard cables. Continue separating the bezel with your fingers and remove it. Unsnap three wireless card antenna cables from the wireless card. Unroute the wireless card antenna cables. Remove five screws securing the display hinges two from the left hinge and three from the right hinge. STEP 16 Remove four screws securing the display hinges on the back. STEP 18 Remove six screws securing the top cover assembly.
Unplug the finger scanning device Gateway 8510 ATI Display from the motherboard.
If you wish, you can remove the wireless card here. STEP 19 Start removing the top cover assembly. It can be a challenge. The top cover is still attached to the bottom with a cable pointed with the red arrow.
By the way, you can access the Bluetooth module from here too. Remove the top cover assembly.

On the picture below you can see the finger scanning device attached to the top cover. This is a very nice part at the price.
77,300 results
This particular drive was split into two partitions. Gateway 8510 ATI Display folks may like to reclaim this space, but I think that including it is a nice touch. When you boot the GZ it prompts you whether you want to go into the recovery console. I checked it out, and it looks a lot like a SUSE Linux install — very clean and easy to understand options.

You can opt for a full restore with format or a system Gateway 8510 ATI Display old files backed-up. The recovery partition is adequately protected from accidental deletion. It is relatively quiet when reading and writing. It is nice to see drives like this trickling Gateway 8510 ATI Display, but I have not heard anything about TSST before so your guess is as good as mine regarding reliability.
I would have liked to see MB, but I guess compromises had to be made in order to hit a price point. It looks good in natural light, but might cause a headache in an office environment. The refresh rate was very good when watching movies and playing games.