EVGA X58 SLI3 Driver
1GB RAM Memory for EVGA X58 SLI3 (GTETR) (DDR NonECC) Motherboard Memory Upgrade by US Seller: : Electronics. Yes, it should work. Pcie is backwards compatible. Just make sure you have the necessary power cables. Also check if there are any bios. EVGA X58 SLI3 Mainboard Socket Intel X58 DDR3 Memory ATX socket: LGA; Max. number of processors: 1; Chip set: Intel X58 Express / Intel ICH10R.
|Supported systems:||Windows Vista (32/64-bit), Windows XP (32/64-bit), Windows 8, Windows 10|
|Price:||Free* [*Free Registration Required]|
EVGA X58 SLI3 Driver
Evga X58 SLI3, LGA 1366/Socket B, Intel (131-GT-E767-TR) Motherboard
Chassis Back Panel Connectors 15 EVGA X58 SLI3 Installation This section will guide you through the installation of the motherboard. The topics covered in this section are: Hold the processor only by the edges and do not touch the EVGA X58 SLI3 of the processor. Use the following procedure to install the CPU onto the motherboard: Unhook the socket lever by pushing down and away from the socket.
Put your EVGA X58 SLI3 on the tail of the load plate and press down with light pressure to lift the load plate up. Lift the load plate.
Remove the EVGA X58 SLI3 socket cover from the CPU Socket. Remove the process from its protective cover, making sure you hold it only by the edges. It is a good idea to save the cover so that EVGA X58 SLI3 you remove the CPU you have a safe place to store it.
Align the notches in the processor with the notches EVGA X58 SLI3 the socket. Lower the processor straight down into the socket with out tilting or sliding it into the socket Note: Make sure the CPU is fully seated and level in the socket. Close the load plate over the CPU and press down while you close and engage the socket lever. The CPU installation is complete. Follow the instruction that came with you fan assembly. Be sure that the fan EVGA X58 SLI3 is correct for your chassis type and your fan assembly.
There must be at least one memory bank populated to ensure normal operation.
User s Guide. EVGA X58 SLI3 Motherboard - PDF
Use the following the recommendations for installing memory. See Figure 1 on page 13 for the location of the memory slots.
DIMM slots 1 and 3. DIMM slots 2, 1, 4, and 3. DIMM slots 1, 3 and 5.
If using more than 4 DIMMs, use: Note that there is only one gap near the EVGA X58 SLI3 of the DIMM slot. This slot matches the slot on the DIMM to ensure the component is installed properly.
EVGA X58 SLI review - Photos - eVGA X58 SLI (3)
Unlock a DIMM slot by pressing the EVGA X58 SLI3 clips outward. Determine if it would be easier to make all the connections prior to this step or to secure the motherboard and then make all the connections. It is normally easier to secure the motherboard first. Be sure that the CPU fan assembly has enough EVGA X58 SLI3 for the system case covers to lock into place and for the expansion cards. Also make sure the CPU Fan assembly is aligned with the vents on the covers.
EVGA X58 SLI3 will depend on the system case being used. If there are studs that do not align with a mounting hole on the motherboard, it EVGA X58 SLI3 recommended that you remove that stud to prevent the possibility of a short circuit. In most cases, it is recommended to secure the motherboard using a minimum of nine 9 spacers and screws.